Deskval
Projection

Show the instruction on the work, not on a screen

Deskval Workbench projects the instruction onto the work surface, so the operator sees what goes where without looking up. Add a depth camera and the bench becomes a touch surface: to confirm a step, reach for the projected button.

What is light guided assembly?

Light guided assembly projects the instruction onto the surface in front of the operator. There is no looking back and forth between a screen and the part: the next step, the place the part goes and the point to watch appear exactly where the work is done.

Deskval does this with an ordinary projector. You design the projected image in the same editor as the operator screen. Add a depth camera and the surface also senses the hand, which brings in virtual buttons, pick-to-light and part checks.

How it works

You design the projected image the same way you design the operator screen.

  1. 1

    Design the projected image

    Draw a second screen for each step: drag text, pictures, arrows and frames into place.

  2. 2

    Point the projector at the bench

    The image lands on the work surface, and a calibration wizard matches the projector with the camera.

  3. 3

    The operator sees it on the work

    The projected image changes with the step, so the place to look is always at hand.

  4. 4

    A hand confirms

    The operator reaches for the projected button and pulls back, and the next step opens. No turning to a screen or a keyboard.

Your bench becomes an interactive surface

Add a depth camera to the projector and the surface does more than show: it sees the operator’s hand and the part.

Virtual buttons

Next step, previous step, reject or rework: the button is projected onto the bench and works when a hand reaches for it.

Pick-to-light

The bin to pick from lights up, and a hand reaching into the wrong one is warned. No modules on the racks.

Is the part in place?

The camera checks that a part has been placed or that an area has been cleared; the step does not move on until the condition is met.

The right image at every step

The projected content changes with the step, and elements that belong on every step are defined once.

One editor, one job

The operator screen, the projected image and the logic behind them live in the same job; no separate software.

Buttons tie into your flow

A virtual button can switch a signal in the PLC or run logic you have built.

Where it pays off

Large, bulky parts

The operator does not walk around the part to see a screen; the instruction lands next to it.

Assemblies where order matters

Screw sequence, connector position, label placement: at every step the point to look at is marked with light.

Stations where a screen is out of reach

No touchscreen or mouse is needed to confirm; reaching for the projected button is enough.

New operators

Someone doing the job for the first time sees what goes where on the spot, and training takes less time.

Frequently asked questions

What hardware does it need?

A projector facing the work surface is enough; it connects to the computer as a second screen. For virtual buttons, pick-to-light and part checks, a depth camera is added.

Can I use projection alone, without a camera?

Yes. On its own, projection works as a second instruction screen. The camera is needed for the features where the surface has to sense your hand or the part.

What can a virtual button do?

Next step, previous step, reject and rework come ready to use. You can also tie a button to your own logic or to a PLC signal.

Who prepares the projected image?

The person who prepares the operator screen, in the same editor and the same way: by drag and drop. No separate design tool and no code.

Does it work together with pick-to-light?

Yes. The same projector and the same camera serve both.

See projection on your own bench

Tell us about your product and your station, and we will work out the right setup together.